
Not less than 2 feet (610 mm) above the highest Mm) in size or are located less than 8 feet (2438 mm)įrom a vertical wall or similar obstruction, shall terminate Vertical wall or similar obstruction shall terminateĪbove the roof in accordance with Figure 802.6.2 and Gas vents that are 12 inches (305 mm) or less in sizeĪnd located not less than 8 feet (2438 mm) from a.Shall be sized in accordance with approved engineeringĪ gas vent shall terminate in accordance with one of the following: Chimney venting systems using mechanical draft.Times the smallest draft hood outlet area. The smaller draft hood outlet, or exceeding seven
A nimble thimble plus#
Larger draft hood outlet plus 50 percent of the area of
For sizing a chimney venting system connected to twoĪppliances with draft hoods, the effective area of theĬhimney flue shall be not less than the area of the. Hood outlet or exceeding seven times the draft hood Less than the area of the appliance flue collar or draft Of the vent connector and chimney flue shall be not Single appliance with a draft hood, the effective areas For sizing an individual chimney venting system for a. Ĭhimney venting system serving listed appliances withĭraft hoods, Category I appliances, and other appliances listed for use with Type B vents shall be in accordance The room or space in which the appliance is installed shallīe directly connected to the adjacent room or space by aĭoorway, archway, or other opening of comparable size Includes the volume of an adjacent room or space, Rating of the remaining unvented appliances do notĮxceed 20 (0.21 kW/m 3). The vent gases to the outdoors so the aggregate input Venting systems or other approved means for conveying Which it is installed, one or more shall be provided with Rating exceeds 20 British thermal units per hour per cubicįoot (0.21 kW/m 3) of room or space in Section 802.2.1(11) are installed so the aggregate input Where appliances in Section 802.2.1(5) through Specialized appliances of limited input such as laboratory burners or gas lights. Other appliances listed for unvented use and not provided with flue collars.
Not be less than 36 inches (914 mm) vertically andĦ inches (152 mm) horizontally from a surface other Installed in this manner, the draft hood outlet shall Kitchen having a mechanical exhaust system where Where a draft hood is required, in a commercial
Installed with the draft hood in place and unaltered, Water heater, where designed and used solelyįor the sanitizing rinse requirements of a dishwashing A single listed booster-type ( automatic instantaneous).Listed Type 1 clothes dryers exhausted in accordance.Listed hot plates and listed laundry stoves.Built-in domestic cooking units listed and marked.The following appliances shall not be required to be vented: